Tools Required

J 22610 Service Boot Clamp Installer

Important: Take care when handling the mass air flow/intake air temperature (MAF/IAT) sensor. Do not dent, puncture, or otherwise damage the Honeycell located at the air inlet end of the MAF/IAT. Do not touch the sensing elements. Do not allow anything, including cleaning solvents and lubricants, to come in contact with the sensing elements. Use a small amount of a non-silicone based lubricant on the air duct only, to aid in the installation. Do not drop or roughly handle the MAF/IAT sensor.

1. Disconnect the electrical connector of the MAF/IAT sensor.
2. Remove the air intake duct clamps from the MAF/IAT sensor and the throttle body.



3. Remove the air duct clamp at the air cleaner housing.



4. Remove the MAF/IAT sensor.

Important: The embossed arrow on the MAF/IAT sensor indicate the proper air flow direction. The arrow must point toward the engine.

1. Install the MAF/IAT sensor into the air intake duct at the air cleaner housing.



2. Install the new clamp using the J 22610 .



3. Install the air intake duct to the MAF/IAT sensor and the throttle body.
4. Install the clamps.
5. Connect the electrical connector of the MAF/IAT .