Removal Procedure
- Turn off the ignition switch.
- Open the center console door.
- Pull up on the rear of the switch assembly in order to release
the mounting clips; if the switch does not release from the trim plate, perform
the following steps:
| 3.1. | Carefully insert a screwdriver into the access hole located on
the rear of the switch assembly. |
| 3.2. | Gently pull up on the switch. |
- Disconnect the harness
connector (1).
- Remove the switch assembly (2).
Installation Procedure
- Connect the harness connector (1).
- Insert the switch assembly (2) into the front of the center console
trim plate.
- Press into place the rear
of the switch assembly (2) into the console trim plate.
- Close the center console door.
