GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2003 🢒 Corvette 🢒 Brakes 🢒 Antilock Brake System 🢒 Electronic Brake Control Module Replacement

Removal Procedure

    Object Number: 707000 Size: SH
  1. Turn the ignition switch to the OFF position.
  2. Disconnect the EBCM harness connector.
  3. Remove the two insulator nuts (1).
  4. Lift the EBCM/BPMV out of the bracket high enough to allow clearance to remove the insulator mounting bolt and the EBCM.

    5. Object Number: 1415808 Size: SH
  5. Remove the insulator mounting bolt from the EBCM.
  6. Remove the six EBCM to BPMV bolts.
  7. Separate the EBCM from the BPMV by gently pulling apart until separated.
  8. Carefully remove the seal.

    9. The seal may by reused if it is not cut or damaged.

Installation Procedure

    Object Number: 1415808 Size: SH
  1. Clean the BPMV seal surface with alcohol using a clean rag.
  2. Install the seal to the BPMV if it is not cut or damaged.
  3. Install the EBCM to the BPMV.

    4. Notice: Refer to Fastener Notice in the Preface section.

  4. Tighten the six mounting bolts in the following sequence:

    5. Tighten

        • First pass to 3 N·m (27 lb in).
        • Second pass to 6 N·m (53 lb in).

    Important: If the insulator nut was removed it must be replaced with a new insulator nut.

  5. Install the front EBCM insulator mounting bolt.

    6. Tighten
    Tighten the bolt to 14 N·m (10 lb ft).


    Object Number: 707000 Size: SH
  6. Install the EBCM/BPMV into the bracket.
  7. Install the two insulator nuts (1).

    8. Tighten
    Tighten the two insulator nuts to 12 N·m (106 lb in).

  8. Connect the EBCM harness connector.

    9. Important: Both sides of the EBCM harness connector must be engaged with lever before closing.

  9. Turn the ignition switch to the ON position; do NOT start the engine.
  10. Perform the Diagnostic System Check - ABS .