Transmission Fluid Temperature Sensor Replacement Export

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Disconnect the transmission fluid temperature sensor electrical connector.



3. Remove the transmission fluid temperature sensor.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Install the transmission fluid temperature sensor.

Tighten
Tighten the transmission fluid temperature sensor to 27 N·m (20 lb ft).




2. Connect the transmission fluid temperature sensor electrical connector.
3. Lower the vehicle.