GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Notice: Whenever the Instrument Panel Cluster (IPC) is removed from the vehicle, DO NOT set the IPC on its face for more than 15 minutes or damage to the fluid filled air core gages may result.


    Object Number: 95725  Size: SH
  1. Remove the instrument panel cluster (IPC) from the vehicle. Refer to Instrument Cluster Replacement .
  2. Disconnect the instrument panel (IP) dimmer switch or the IP dimmer/head-up display (HUD) switch electrical connector.

  3. Object Number: 95726  Size: SH
  4. Disconnect the driver information center (DIC) switch electrical connector.

  5. Object Number: 95724  Size: SH
  6. Remove the IP cluster bezel retaining screws.
  7. Remove the bezel from the IPC.

  8. Object Number: 95723  Size: SH
  9. Remove the DIC switch retaining screws.
  10. Remove the DIC switch.

Installation Procedure


    Object Number: 95723  Size: SH
  1. Install the DIC switch to the IP cluster bezel.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the DIC switch retaining screws.
  4. Tighten
    Tighten the DIC switch retaining screws to 1.5 N·m (13 lb in).


    Object Number: 95724  Size: SH
  5. Install the bezel to the IPC.
  6. Align the bezel onto the guide pins.

  7. Install the IP cluster bezel retaining screws.
  8. Tighten
    Tighten the IP cluster bezel retaining screws to 1.5 N·m (13 lb in).


    Object Number: 95725  Size: SH
  9. Connect the IP dimmer switch or the IP dimmer/HUD switch electrical connector.

  10. Object Number: 95726  Size: SH
  11. Connect the DIC switch electrical connector.
  12. Install the IPC to the vehicle. Refer to Instrument Cluster Replacement .