Special Tools

J 41099 Gear Select/Reverse Lockout Solenoid Socket

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Disconnect the gear select solenoid electrical connector.



3. Using the J 41099 , remove the gear select solenoid.

Notice: Replacement components must be the correct part number for the application. Components requiring the use of the thread locking compound, lubricants, corrosion inhibitors, or sealants are identified in the service procedure. Some replacement components may come with these coatings already applied. Do not use these coatings on components unless specified. These coatings can affect the final torque, which may affect the operation of the component. Use the correct torque specification when installing components in order to avoid damage.

1. Using the J 41099 , install the gear select (skip shift) solenoid.

Tighten
Tighten the gear select solenoid to 40 N·m (30 lb ft).




2. Connect the gear select solenoid electrical connector.
3. Lower the vehicle.