Tools Required
J 35616 Connector
Test Adapter Kit
Removal Procedure
- Open the console compartment
door.
- Lift up on the IP accessory trim plate (1) to gain access to the
LED wiring connector (2).
- Disconnect the electrical LED connector (2) from the wiring harness
connector (3).
- Use the J 35616
to extract terminals from the LED connector (2).
- Push up on LED (4) from underneath IP accessory trim plate (1)
and remove.
Installation Procedure
- Use the J 35616
to extract terminals from the replacement
LED connector (2).
- Insert LED wiring through opening in the IP accessory trim plate
(1) and press the LED (4) into place.
- Install terminals in LED connector (2).
- Connect the electrical LED connector (2) to the wiring harness
connector (3).
- Position the IP accessory trim plate (1) and press into place.
- Close the console compartment door.