GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2003 🢒 Corvette 🢒 Body and Accessories 🢒 Lighting Systems 🢒 Park/Turn Signal/Side Marker Lamp Replacement

Removal Procedure

    Object Number: 171878 Size: SH
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the front fascia lower closeout panel. Refer to Front Bumper Fascia Lower Close Out Panel Replacement in Bumpers.
  3. Release the brake caliper cooling duct from the front fascia, and position the duct aside.

    4. Object Number: 64639 Size: SH
  4. Remove the front turn signal lamp bracket retaining spring from the lamp bracket.
  5. Remove the lamp bracket retaining spring from the front fascia.
  6. Remove the front turn signal lamp bracket retaining screws.

    7. Object Number: 64634 Size: SH
  7. Disconnect the sockets from the lamp.

    8. Object Number: 64641 Size: SH
  8. Remove the lamp, with the bracket, from the vehicle.
  9. Remove the lamp to bracket retaining screws.
  10. Remove the lamp from the bracket.

Installation Procedure

    Object Number: 64641 Size: SH
  1. Install the front park/turn signal and sidemarker lamp into position on the front turn signal lamp bracket.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the front park/turn signal and sidemarker lamp to bracket retaining screws.

    3. Tighten
    Tighten the front park/turn signal and sidemarker lamp to bracket retaining screws to 2 N·m (18 lb in).


    Object Number: 64634 Size: SH
  3. Install the sockets to the lamp.

    4. Object Number: 64639 Size: SH
  4. Install the lamp, with the bracket, to the front fascia.
  5. Align the lamp to the opening in the front fascia and hold the lamp firmly in place against the fascia, while installing the front turn signal lamp bracket retaining screws.

    6. Tighten
    Tighten the front turn signal lamp bracket retaining screws to 3 N·m (27 lb in).

  6. Install the lamp bracket retaining spring to the front fascia.
  7. Install the front turn signal lamp bracket retaining spring to the lamp bracket.

    8. Object Number: 171878 Size: SH
  8. Position the brake caliper cooling duct to the front fascia and press the duct toward the fascia to secure.
  9. Install the front fascia lower closeout panel. Refer to Front Bumper Fascia Lower Close Out Panel Replacement in Bumpers.