For 1990-2009 cars only
| • | J 39232 Wiper Linkage Separator |
| • | J 39529 Wiper Linkage Installer |
Removal Procedure
- Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
- Using the J 39232 , disconnect the wiper transmission from the wiper motor crank arm to aid in the removal of the wiper drive system module.
- Remove the wiper drive system module screws.
- Remove the wiper drive system module from the cowl area to gain access to the wiper motor electrical connector.
- Disconnect the wiper motor electrical connector.
- Remove the wiper drive system module from the vehicle.
Installation Procedure
- Position the wiper drive system module to the vehicle.
- Connect the wiper motor electrical connector.
- Install the wiper drive system module into the cowl area.
- Install the wiper drive system module screws.
- Using the J 39529 , connect the wiper transmission to the wiper motor crank arm.
- Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
- Inspect the wipers for proper operation.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 10 N·m (89 lb in).
