GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 65091  Size: SH
  1. Remove the front floor kick-up panel. Refer to Front Floor Kick-Up Panel Replacement in Interior Trim.
  2. Remove the cover from the I/P electrical center.
  3. Remove the RDO/CD MiniFuse® #5 from the I/P electrical center.
  4. Remove the console. Refer to Console Replacement in Instrument Panel, Gauges and Console.
  5. Remove the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gauges and Console.
  6. Remove the screws retaining the radio control to the I/P center support bracket.
  7. Begin to remove the radio control from the center support bracket enough to access the connectors at rear of the radio control.

  8. Object Number: 65093  Size: SH
  9. Disconnect the electrical/audio and coaxial cable connectors from the radio control.

  10. Object Number: 65092  Size: SH
  11. Remove the radio control.

Installation Procedure


    Object Number: 65093  Size: SH
  1. Connect the electrical/audio and coaxial cable connectors to the radio control.

  2. Object Number: 65092  Size: SH
  3. Install the radio control into position in the I/P center support bracket.
  4. Align the radio control locator tab into the center support bracket locator hole.


    Object Number: 65091  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the radio control retaining screws.
  6. Tighten
    Tighten the radio control retaining screws to 2.5 N·m (22 lb in).

  7. Install the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gauges and Console.
  8. Install the console. Refer to Console Replacement in Instrument Panel, Gauges and Console.
  9. Install the RDO/CD MiniFuse® #5 to the I/P electrical center.
  10. Install the cover to the I/P electrical center.
  11. Install the front floor kick-up panel. Refer to Front Floor Kick-Up Panel Replacement in Interior Trim.