Notice: Whenever the Instrument Panel Cluster (IPC) is removed from the vehicle, DO NOT set the IPC on its face for more than 15 minutes or damage to the fluid filled air core gages may result.

1. Remove the instrument panel cluster (IPC) from the vehicle. Refer to Instrument Cluster Replacement .
2. Disconnect the instrument panel (I/P) dimmer switch or I/P dimmer/head-up display (HUD) switch electrical connector.



3. Disconnect the driver information center (DIC) switch electrical connector.



4. Remove the I/P cluster bezel retaining screws.
5. Remove the cluster bezel from the IPC.



6. Remove the I/P dimmer switch or I/P dimmer/HUD switch retaining screws.
7. Remove the I/P dimmer switch or I/P dimmer/HUD switch .



8. Remove the DIC switch retaining screws.
9. Remove the DIC switch.

1. Install the DIC switch to the I/P cluster bezel.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the DIC switch retaining screws.

Tighten
Tighten the DIC switch retaining screws to 1.5 N·m (13 lb in).




3. Install the I/P dimmer switch or I/P dimmer/HUD switch to the bezel.
4. Install the I/P dimmer switch or I/P dimmer/HUD switch retaining screws.

Tighten
Tighten the I/P dimmer switch or I/P dimmer/HUD switch retaining screws to 1.5 N·m (13 lb in).




5. Install the bezel to the IPC.

Align the bezel onto the guide pins.

6. Install the I/P cluster bezel retaining screws.

Tighten
Tighten the I/P cluster bezel retaining screws to 1.5 N·m (13 lb in).




7. Connect the I/P dimmer switch or I/P dimmer/HUD switch electrical connector.



8. Connect the DIC switch electrical connector.
9. Install the IPC to the vehicle. Refer to Instrument Cluster Replacement .