GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 25070 Heat Gun

Removal Procedure


    Object Number: 63773  Size: SH
  1. When replacing an emblem/nameplate, do the following:
  2. 1.1. Use tape to protect the mounting surface during removal.
    1.2. Use tape for alignment marks for installation of the emblem/nameplate.
  3. To remove an emblem/nameplate, heat the emblem/nameplate using a J 25070 .
  4. Apply the heat using a circular motion for about 30 seconds holding the J 25070 approximately 152 mm (6 in) from the surface.
  5. Notice: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.

  6. Use a plastic, flat-bladed tool to remove the emblem/nameplate from the panel surface.

Installation Procedure


    Object Number: 63773  Size: SH
  1. Heat the mounting surface to approximately 27-41°C (80-105°F) using the J 25070 , if necessary.
  2. Ensure that the temperature of the emblem/nameplate is approximately 29-32°C (85-90°F).
  3. Important: Do not touch the adhesive backing on the emblem/nameplate.

  4. Remove the protective liner from the back of the emblem/nameplate.
  5. Position the emblem:
  6. • Centered to the centerline of the vehicle
    • 37 mm (1.5 in) forward of the rear edge of the lift window panel
  7. Apply equal pressure along the emblem/nameplate to uniformly bond the item to the mounting surface.
  8. Remove the protective tape from the mounting surface.