Tools Required

J 25070 Heat Gun

1. When replacing an emblem/nameplate, do the following:

1.1.	Use tape to protect the mounting surface during removal.

1.2.	Use tape for alignment marks for installation of the emblem/nameplate.

2. To remove an emblem/nameplate, heat the emblem/nameplate using a J 25070 .
3. Apply the heat using a circular motion for about 30 seconds holding the J 25070 approximately 152 mm (6 in) from the surface.

Notice: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.

4. Use a plastic, flat-bladed tool to remove the emblem/nameplate from the panel surface.

1. Heat the mounting surface to approximately 27-41°C (80-105°F) using the J 25070 , if necessary.
2. Ensure that the temperature of the emblem/nameplate is approximately 29-32°C (85-90°F).

Important: Do not touch the adhesive backing on the emblem/nameplate.

3. Remove the protective liner from the back of the emblem/nameplate.
4. Install the emblem to the locator holes in the fascia.
5. Apply equal pressure along the emblem/nameplate to uniformly bond the item to the mounting surface.
6. Remove the protective tape from the mounting surface.