Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Door Control Module Schematics Connector End View Reference: Power Door Systems Connector End Views | |||
1 | Did you perform the Door Systems Diagnostic System Check? | Go to Step 2 | |
2 | Verify that the heated mirrors inoperative fault is present. Do the heated mirrors operate normally? | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 |
Does the rear defogger operate correctly? | Go to Step 4 | |
4 |
Does the test lamp illuminate? | Go to Step 5 | Go to Step 6 |
5 |
Does the test lamp illuminate? | Go to Step 8 | Go to Step 7 |
6 | Test the mirror heater battery positive voltage circuit for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 12 | Go to Step 9 |
7 | Test the mirror heater ground circuit for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 12 | Go to Step 9 |
8 | Inspect for poor connections at the harness connector of the appropriate outside rearview mirror. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 12 | Go to Step 10 |
9 | Inspect for poor connections at the harness connector of the driver door module (DDM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 12 | Go to Step 11 |
10 | Replace the appropriate outside rearview mirror. Refer to Outside Rearview Mirror Replacement . Did you complete the replacement? | Go to Step 12 | -- |
11 | Replace the driver door module. Refer to Door Control Module Replacement . Did you complete the replacement? | Go to Step 12 | -- |
12 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 2 |
