GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2003 🢒 Corvette 🢒 Body and Accessories 🢒 Roof 🢒 Lift Off Panel Weatherstrip Retainer Replacement

Removal Procedure

    Object Number: 63735 Size: SH
  1. Remove the roof panel , place the roof panel upside down on a flat protective surface.
  2. Remove the side weatherstrip. Refer to Lift Off Panel Weatherstrip Replacement .

    3. Object Number: 284764 Size: SH
  3. Remove the screws attaching the retainer to the roof panel .
  4. Remove the retainer.

Installation Procedure

    Object Number: 284764 Size: SH
  1. Position the retainer to the roof panel, ensure that the molded end of the rubber is located towards the front of the roof panel .

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the forward screw aligning the retainer fore and aft.

    3. Important: Stripped, broken, or improperly seated screws must be replaced or repaired to prevent water leaks.

  3. Install the remaining screws.

    4. Tighten
    Tighten the side weatherstrip retainer screws to 3 N·m (27 lb in).

  4. Install the roof panel.