GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2003 🢒 Corvette 🢒 Preface 🢒 Cautions and Notices 🢒 Instrument Panel Disassembly Precautions

Important: The instrument panel (I/P) bracket locations MUST be marked PRIOR to disassembly.

The original locations of the I/P brackets are required for proper trim fit. PRIOR to disassembling the I/P brackets, mark their locations using a paint stick, grease pencil, or other suitable method. The following is a list of the I/P brackets which should be marked and the recommended locations for marking them:

   • 
Object Number: 95745 Size: SH
  • The steering column bracket (1):

    • Mark the bracket (1) in relation to the I/P upper and lower support beams.

       • 
    Object Number: 95749 Size: SH
  • The passenger SIR bracket (2):

    • Mark the bracket (2) in relation to the I/P upper and lower support beams.

       • 
    Object Number: 95751 Size: SH
  • The I/P center support bracket (3), LH side:

    • Mark the bracket (3), LH side, in relation to the I/P lower support beam and the driveline tunnel; mark the ignition switch housing bracket (7), connected to the I/P center support bracket (3), in relation to the steering column bracket.

       • 
    Object Number: 95752 Size: SH
  • The I/P center support bracket (3), RH side:

    • Mark the bracket (3), RH side, in relation to the I/P lower support beam, the driveline tunnel, and the passenger knee bolster bracket (6).

       • 
    Object Number: 95746 Size: SH
  • The driver knee bolster outer bracket (4):

    • Mark the bracket (4) in relation to the steering column bracket (1).

       • 
    Object Number: 95748 Size: SH
  • The driver knee bolster bracket (5):

    • Mark the bracket (5) in relation to the steering column bracket (1).

       • 
    Object Number: 95750 Size: SH
  • The passenger knee bolster bracket (6):

    • Mark the bracket (6) in relation to the passenger SIR bracket (2).

       • 
    Object Number: 95754 Size: SH
  • The ignition switch housing bracket (7):

    • Mark the bracket (7) in relation to the I/P center support bracket (3).