Removal Procedure
- Remove the oil level indicator.
- Remove the oil level indicator tube bolt.
- Remove the oil level indicator tube.
- Remove the O-ring from the oil level indicator tube, if required.
Important: Inspect the O-ring seal for cuts or damage. The O-ring seal may be reused if not cut or damaged.
Installation Procedure
- Lubricate the O-ring seal with clean engine oil.
- Install the oil level indicator tube into position.
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Insert the oil level indicator tube into the engine block until the collar is flush with the block.
- Lower the vehicle.
- Install the oil level indicator tube bolt.
- Install the oil level indicator.
- Check the oil level and add if necessary.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the oil level indicator tube bolt to 25 N·m (18 lb ft).
