GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2003 🢒 Corvette 🢒 General Information 🢒 General Information 🢒 Rear License Plate Bracket Replacement

Removal Procedure

    Object Number: 64620 Size: SH
  1. Remove the license plate frame.
  2. Remove the license plate screws.
  3. Remove the license plate.
  4. Remove the license plate bracket screws.
  5. Partially remove the license bracket to expose the back-up lamp sockets.
  6. Remove the back-up lamp sockets.
  7. Remove the license bracket.

Installation Procedure

    Object Number: 64620 Size: SH
  1. Align the license bracket with the center locating tab in the slot in the fascia.
  2. Install the back-up lamp sockets.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the license bracket screws.

    4. Tighten
    Tighten the license bracket screws to 2 N·m (18 lb in).

  4. Install the license plate.
  5. Install the license plate screws

    6. Tighten
    Tighten the license bracket screws to 2 N·m (18 lb in).

  6. Install the license plate frame.