Power Window and/or Door Lock Inoperative - keywords B2282 B2283 B2284 B2285 channel conn connector elec electrical glass ground guide HVAC IP info information inop inoperative int intermittent latch

The following diagnosis might be helpful if the vehicle exhibits the symptom(s) described in this PI.

Power door lock or power window may be inoperative or intermittently may not work from one of the doors.

While attempting to operate the function, grab the conduit of the C201 connector and move it back and forth. If the function now operates, check corresponding connectors to ensure that all of the connector pins are fully seated and are free of any corrosion.

Care should be taken to check for a deformed (too large internal diameter) female pin. Replace loose/damaged female terminals in connector. Usually terminals A, B, C (power and/or ground) C200 and C201 are located in corresponding "A" pillar just inboard of door hinge area harness conduit/pass-through.

Please follow this diagnostic or repair process thoroughly and complete each step. If the condition exhibited is resolved without completing every step, the remaining steps do not need to be performed.