GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2004 🢒 Corvette 🢒 Transmission/Transaxle 🢒 Shift Lock Control 🢒 Automatic Transmission Shift Lock Control Actuator Replacement

Removal Procedure

    Object Number: 73236 Size: SH
  1. Remove the console. Refer to Console Replacement in Instrument Panel, Gages and Console.
  2. Remove the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gages and Console.
  3. Disconnect the floor shift control electrical connector.
  4. Disconnect the I/P wiring harness clip from the floor shift control and reposition the harness.
  5. Remove the shift control boot. Refer to Floor Shift Control Boot Replacement .

    6. Object Number: 190956 Size: SH
  6. Disconnect the automatic transmission shift lock control actuator electrical connector.

    7. Object Number: 190958 Size: SH
  7. Using a flat-bladed screwdriver, carefully unsnap the automatic transmission shift lock actuator lower clip attachment from the shift control pivot arm stud.

    8. Object Number: 190963 Size: SH
  8. Allow the solenoid plunger to extend while positioning the plunger (with lower attachment) above the shift control pivot arm stud.
  9. Carefully unsnap the remaining automatic transmission shift lock actuator clip attachment.

    10. Rotate the solenoid body clockwise slightly while unsnapping the clip from the bottom with a flat-bladed screwdriver.


    Object Number: 191021 Size: SH
  10. Remove the automatic transmission shift lock actuator from the floor shift control.

Installation Procedure

    Object Number: 190963 Size: SH
  1. Insert the automatic transmission shift lock actuator lower clip attachment just above the installed position on the shift control pivot arm.
  2. Twist and press the automatic transmission shift lock actuator upper clip attachment onto the pivot point.

    3. Begin to install the top of the upper clip attachment, then pivot the attachment downward while pressing to secure.


    Object Number: 190958 Size: SH
  3. Position the automatic transmission shift lock actuator lower clip attachment onto the shift control pivot arm stud and push to secure.

    4. Object Number: 190956 Size: SH
  4. Connect the automatic transmission shift lock actuator electrical connector.

    5. Object Number: 73236 Size: SH
  5. Install the shift control boot. Refer to Floor Shift Control Boot Replacement .
  6. Connect the I/P wiring harness clip to the shift control.
  7. Connect the floor shift control electrical connector.
  8. Install the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gages and Console.
  9. Install the console. Refer to Console Replacement in Instrument Panel, Gages and Console.