- Mark or scribe the end of the crankshaft and the manual transmission flywheel. Refer to Engine Balancing .
- Remove the flywheel bolts.
- Remove the manual transmission flywheel.
- Note the location of the manual transmission flywheel balance weights, if applicable. Refer to Engine Balancing .
- Remove the automatic transmission flex plate.
Important:
• For manual transmission applications, note the position and direction of the engine flywheel before removal. The flywheel does not use a locating pin for alignment. Mark or scribe the end of the crankshaft and the flywheel before component removal.
The existing manual transmission engine flywheel must be installed to the original position and direction. The engine flywheel will not initially seat against the crankshaft flange, but will be pulled onto the crankshaft by the engine flywheel bolts. This procedure
requires a 3 stage tightening process. • Do not remove the propeller shaft hub or flex plate from the automatic transmission flex plate assembly. The flex plate assembly, with propeller shaft hub, is balanced as an assembly. If service is required, the entire flex plate assembly should
be replaced.
