GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 Corvette 🢒 Vehicle Control Systems 🢒 Vehicle DTC Information 🢒 Radio Replacement

Removal Procedure

    Object Number: 1237162 Size: SH
  1. Remove the cover from the instrument panel (I/P) electrical center.
  2. Remove the RDO/CD MiniFuse® #5 from the I/P electrical center.
  3. Remove the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gages, and Console.
  4. Remove the HVAC control module. Refer to HVAC Control Module Replacement .
  5. Remove the screws retaining the radio control to the I/P center support bracket.
  6. Begin to remove the radio control from the center support bracket enough to access the connectors at rear of the radio control.
  7. Disconnect the electrical/audio and coaxial cable connectors from the radio control.
  8. Remove the radio control.

Installation Procedure
  1. Connect the electrical/audio and coaxial cable connectors to the radio control.
  2. Install the radio control into position in the I/P center support bracket.

    3. Align the radio control locator tab into the center support bracket locator hole.

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1237162 Size: SH
  3. Install the radio control retaining screws.

    4. Tighten
    Tighten the screws to 2.5 N·m (22 lb in).

  4. Install the HVAC control module. Refer to HVAC Control Module Replacement .
  5. Install the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gages, and Console.
  6. Install the RDO/CD MiniFuse® #5 to the I/P electrical center.
  7. Install the cover to the I/P electrical center.
  8. Refer to Control Module References for programming and setup information.