Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
Schematic Reference: OnStar Schematics Connector End View Reference: Cellular Communication Connector End Views DEFINITION: The OnStar® Call Center operator can clearly be heard but the operator is unable to hear the caller. | ||||
1 | Did you perform the Diagnostic System Check - Vehicle? | -- | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
2 |
Does the OnStar® operator hear your voice? | -- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 |
Does the voltage measure greater than the specified value? | 9 V | Go to Step 5 | Go to Step 6 |
4 | Measure the voltage from the cellular microphone battery positive voltage circuit to a good ground. Does the voltage measure greater than the specified value? | 11 V | Go to Step 5 | Go to Step 9 |
5 | Measure the voltage from the cellular microphone signal circuit to the drain wire. Does the voltage measure greater than the specified value? | 9 V | Go to Step 8 | Go to Step 7 |
6 | Test the cellular microphone signal circuit for an open or short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 15 | Go to Step 10 |
7 | Test the drain wire for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 15 | Go to Step 11 |
8 | Test the cellular microphone low reference for a short to ground. Did you find and correct the condition? | -- | Go to Step 15 | Go to Step 12 |
9 | Test the cellular microphone battery positive voltage circuit for an open. Did you find and correct the condition? | -- | Go to Step 15 | Go to Step 12 |
10 |
Did you find and correct the condition? | -- | Go to Step 15 | Go to Step 11 |
11 | Inspect for poor connections at the harness connector of the cellular microphone. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 15 | Go to Step 14 |
12 | Inspect for poor connections at the harness connector of the VCIM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 15 | Go to Step 13 |
13 | Replace the cellular microphone assembly. Refer to Mobile Telephone Microphone Replacement . Did you complete the replacement? | -- | Go to Step 15 | -- |
14 | Replace the VCIM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? | -- | Go to Step 15 | -- |
15 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 2 |
