Removal Procedure
- Remove the door trim panel.Refer to
Front Side Door Trim Panel Replacement - Left Side
or
Front Side Door Trim Panel Replacement - Right Side
.
- Disconnect the electrical connector to the
mirror wire harness.
Caution: Approved safety glasses and gloves should be worn when performing this
procedure to reduce the chance of personal injury.
- Remove the mirror face. Refer to
Mirror, Mirror Face Replacement - Front Door
.
- Remove the screws from the mirror motor.
- Pull the motor electrical harness through the mirror housing.
- Remove
the motor from the mirror housing.
Installation Procedure
- Position
the motor to the mirror housing.
- Pull the motor electrical harness through the mirror housing to the inside
door panel.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the screws to the mirror motor.
Tighten
Tighten the mirror motor screws to 10 N·m
(89 lb in).
- Install the mirror face to the mirror housing. Refer to
Mirror, Mirror Face Replacement - Front Door
.
- Connect the electrical connector to the
mirror wire harness.
- Check the operation of the mirror.
- Install the door trim panel. Refer to
Front Side Door Trim Panel Replacement - Left Side
or
Front Side Door Trim Panel Replacement - Right Side
.