GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 Corvette 🢒 Transmission/Transaxle 🢒 Clutch 🢒 Clutch Pedal Position Switch Replacement

Removal Procedure

    Caution: Refer to Battery Disconnect Caution in the Preface section.


    Object Number: 71479 Size: SH
  1. Disconnect the negative battery cable.
  2. Remove the clutch pedal position switch (clutch start switch) electrical connector.

    3. Object Number: 71492 Size: SH
  3. Insert a feeler gage between the switch and the clutch pedal bracket to release the switch tab.
  4. Remove the switch.

    5. Lift the switch slightly then pull to remove.

Installation Procedure

    Object Number: 71478 Size: SH
  1. Install the clutch pedal position switch (clutch start switch) to the clutch pedal bracket.

    2. Insert the switch locators into the top of the slots, then slide down to lock.


    Object Number: 71479 Size: SH
  2. Connect the switch electrical connector.

    3. Notice: Refer to Fastener Notice in the Preface section.

  3. Connect the negative battery cable.

    4. Tighten
    Tighten the negative battery cable bolt to 15 N·m (11 lb ft).

  4. Program the transmitters. Refer to Transmitter Programming .