GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 Corvette 🢒 HVAC 🢒 HVAC Systems - Automatic 🢒 Inside Air Temperature Sensor Replacement

Removal Procedure
  1. Remove the knee bolster. Refer to Driver Knee Bolster Panel Replacement in Instrument Panel, Gages and Console.
  2. Remove the driver information center (DIC) retaining screw.
  3. Disconnect DIC from the instrument panel (I/P).
  4. Disconnect the inside air temperature sensor from the DIC bezel.

    5. Object Number: 922611 Size: SH
  5. Disconnect the inside air temperature sensor electrical connector.

Installation Procedure
  1. Connect the inside air temperature sensor electrical connector.

    2. Important: Ensure that the inside temperature sensor is fully seated into the DIC bezel.


    Object Number: 922611 Size: SH
  2. Install the inside air temperature sensor.
  3. Connect DIC to the I/P.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the DIC retaining screw.

    5. Tighten
    Tighten the screw to 1.9 N·m (17 lb in).

  5. Install the knee bolster. Refer to Driver Knee Bolster Panel Replacement in Instrument Panel, Gages and Console.