Malfunction Indicator Lamp (MIL), Diagnostic Trouble Code (DTC) P0833, Cruise Control Inoperative (Adjust Clutch Release Switch)
| Subject: | Malfunction Indicator Lamp (MIL), Diagnostic Trouble Code (DTC) P0833, Cruise Control Inoperative (Adjust Clutch Release Switch) |
| Models: | 2005 Chevrolet Corvette |
| with Manual Transmission (RPO MN6) |
Condition
Some customers may comment of a Malfunction Indicator Lamp .
Some customers may comment that the cruise control is inoperative.
A scan tool may reveal a DTC P0833.
Cause
The Clutch Release Switch may be misadjusted.
Diagnostic Information
There are two clutch switches
| • | The lower switch, the Clutch Pedal Position (CPP) Switch provides feedback to the PCM that the clutch pedal has been depressed to enable starting. The CPP Switch DOES NOT relate to the P0883 code. |
| • | The upper switch, the Clutch Release Switch also referred to in SI as the Clutch Cruise Control Release Switch, provides the PCM feedback as to the position of the clutch pedal. |
| • | Refer to Manual Transmission Component Views, Figure 2: 01 Y-Car: Comp Loc Views (Under LH Side of the Dash) SI Document ID # 714735 for switch locations. |
Important: Multiple clutch presses during a single stop may provide inaccurate feedback to the PCM and the technician may misdiagnose the need to replace the PCM. The Tech 2® may not pick up the multiple presses which would appear that the PCM is not picking up the signal. The PCM should not be replaced if the Tech 2® does not pick up multiple clutch cycles during testing.
For additional information of DTC P0833, refer to SI Document ID # 1394327.
Correction
DO THIS | DON'T DO THIS |
|---|---|
Adjust the Clutch Release Switch | DO NOT replace the PCM P/N 12578554 or P/N 12597883 |
- Adjust the Clutch Release Switch. Refer to Clutch Release Switch Replacement SI Document ID # 1556170.
- Once the Clutch Release Switch is adjusted, secure the Clutch Release Switch wiring harness with electrical tape or a plastic tie to a surrounding harness to insure the switch does not rotate and become misadjusted again.
- Clear the DTC with a scan tool.
Warranty Information
For vehicles repaired under warranty, use:
Labor Operation | Description | Labor Time |
|---|---|---|
R1245 | Switch, Cruise Control Release - Clutch - R&R Or Replace | Use Published Labor Time |
