Convertible Top Tonneau Cover Will Not Latch, Tonneau Ajar Message in Driver Information Center (DIC) (Reprogram Folding Top Module [FTM])

Some customers may comment that when lowering the convertible top, the tonneau cover does not close all the way. A "TONNEAU AJAR" message may appear on the Driver Information Center (DIC).

The power pull-down actuator striker begins to cycle before the tonneau latch is fully engaged; therefore no pull-down occurs.

Inspect to make sure that the pull-down actuator is properly aligned in the center of the tonneau latch. If the actuator is off to the right (passenger side), it will also cause the same condition. Adjust the pull-down actuator to the center or slightly left of center.

If adjusting the pull-down actuator does not correct the condition, then recalibrate the folding top module (FTM) with an updated software calibration using the Tech 2® following the procedure below.

Important: The Tech 2® must contain software version 24.005 or later.

1. Install the Tech 2® to the vehicle and power on.
2. Select "F0 Diagnostic" from the menu.
3. Build the vehicle from the menu options.
4. Select "F0 Vehicle Control Systems" from the menu.
5. Select "Computer/Integrating Systems".
6. Select "Module Setup" from the menu.
7. Select "Folding Top Module" from the menu.
8. Select "Recalibration" from the menu. The FTM calibration ID should change from 9 to 10. This can be verified through Module ID Information.

For vehicles repaired under warranty, use: