GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 1237162  Size: SH
  1. Remove the cover from the instrument panel (I/P) electrical center.
  2. Remove the RDO/CD MiniFuse® #5 from the I/P electrical center.
  3. Remove the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
  4. Remove the HVAC control module. Refer to HVAC Control Module Replacement .
  5. Remove the screws retaining the radio control to the I/P center support bracket.
  6. Begin to remove the radio control from the center support bracket enough to access the connectors at rear of the radio control.
  7. Disconnect the electrical/audio and coaxial cable connectors from the radio control.
  8. Remove the radio control.

Installation Procedure

  1. Connect the electrical/audio and coaxial cable connectors to the radio control.
  2. Install the radio control into position in the I/P center support bracket.
  3. Align the radio control locator tab into the center support bracket locator hole.

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1237162  Size: SH
  4. Install the radio control retaining screws.
  5. Tighten
    Tighten the screws to 2.5 N·m (22 lb in).

  6. Install the HVAC control module. Refer to HVAC Control Module Replacement .
  7. Install the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
  8. Install the RDO/CD MiniFuse® #5 to the I/P electrical center.
  9. Install the cover to the I/P electrical center.
  10. Refer to Control Module References for programming and setup information.