For 1990-2009 cars only
Removal Procedure
- Using a heat gun heat the protector/molding to soften the adhesive.
- Lift upward to remove the protector.
- Remove all old adhesive from the lid depression by using 3M™ adhesive remover P/N 8984 or equivalent.
- Clean the surface with a 50/50 mixture of isopropyl alcohol and water.
- Dry the surface with a clean cloth.
Installation Procedure
- Using a heat gun preheat the adhesive on the new protector.
- Peel the backing from the protector.
- Position the protector inside the lid depression with the ends of the protector flush with the forward edge of the lid.
- Press the protector firmly into the lid depression.
