For 1990-2009 cars only
Removal Procedure
- Remove the seat. Refer to Driver and Passenger Seat Replacement .
- Remove the seat belt pretensioner and buckle. Refer to Seat Belt Buckle Pretensioner Replacement .
- Remove the seat cushion cover and foam. Refer to Front Seat Cushion Cover and Pad Replacement .
- For non-power seats, remove the adjuster adjustment bar.
- Reposition the lumbar pump, if equipped.
- Remove the tie straps and reposition the pump and pouch up through the seat support wires .
- Remove the seat belt harness from the left seat frame.
- Remove the memory seat control module, if equipped.
- Remove the fasteners mounting the seat to the adjuster.
- Remove the adjuster.
- Transfer the parts as necessary.
Installation Procedure
- Install the adjuster to the seat. Tighten the fasteners to the seat.
- For non-power seats, align the adjusters with their locking pawls engaged in the same slots side to side.
- Install the seat adjuster adjustment bar.
- Install the lumbar pump, if equipped.
- Connect the seat belt harness to the left seat.
- Install the memory seat control module to the seat spring wire, if equipped.
- Install the seat belt pretensioner and buckle. Refer to Seat Belt Buckle Pretensioner Replacement .
- Install the seat cushion foam and cover. Refer to Front Seat Cushion Cover and Pad Replacement .
- Install the seat. Refer to Driver and Passenger Seat Replacement .
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the adjuster fasteners to 24 N·m (18 lb ft).
Important: When working on the passenger seat the convoluted tubing for the lumbar pump must lay over the aluminum bracket and be zip tied in place.
