For 1990-2009 cars only
Removal Procedure
- Remove the left side engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
- Disconnect the quick connect fitting (1) at the front of dash. Refer to Heated Oxygen Sensor Replacement - Bank 2 Sensor 1 .
- Disconnect the chassis fuel bundle retainer (1) from the upper front of dash mounting stud (3).
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the exhaust intermediate pipe. Refer to Intermediate Pipe Replacement .
- Remove the floor panel tunnel reinforcement. Refer to Floor Panel Tunnel Panel Reinforcement Replacement .
- Disconnect the front chassis vacuum line from the underbody retainers (6).
- Disconnect the front chassis vacuum line quick connect fitting (1) located on the left side of the vehicle, forward of the rear drive module. Refer to Heated Oxygen Sensor Replacement - Bank 2 Sensor 1 .
- Remove the front chassis vacuum line from the vehicle.
Installation Procedure
- Install the front chassis vacuum line to the vehicle.
- Connect the front chassis vacuum line quick connect fitting (1). Refer to Heated Oxygen Sensor Replacement - Bank 2 Sensor 1 .
- Connect the front chassis vacuum line to the underbody retainers (6).
- Install the floor panel tunnel reinforcement. Refer to Floor Panel Tunnel Panel Reinforcement Replacement .
- Install the exhaust intermediate pipe. Refer to Intermediate Pipe Replacement .
- Lower the vehicle.
- Connect the chassis fuel bundle retainer (1) to the upper front of dash mounting stud (3).
- Connect the quick connect fitting (1) at the front of dash. Refer to Heated Oxygen Sensor Replacement - Bank 2 Sensor 1 .
- Install the left side engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
