Exhaust System Insulator, Hanger, Bracket Replacement Exhaust Muffler

1. Remove the muffler. Refer to Exhaust Muffler Replacement - Left Side or Exhaust Muffler Replacement - Right Side .
2. Remove the muffler hanger nuts and hanger.
3. Remove the push-on retainer, if necessary.
4. Remove the hanger reinforcement, if necessary.

1. Install the hanger reinforcement, if necessary.
2. Install the push-on retainer, if necessary.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the muffler hanger and nuts.

Tighten
Tighten the muffler hanger nuts to 16 N·m (12 lb ft).

4. Install the muffler. Refer to Exhaust Muffler Replacement - Left Side or Exhaust Muffler Replacement - Right Side .

Exhaust System Insulator, Hanger, Bracket Replacement Exhaust Pipe Rear

1. Remove the intermediate exhaust pipe. Refer to Intermediate Pipe Replacement .
2. Remove the floor panel tunnel reinforcement. Refer to Floor Panel Tunnel Panel Reinforcement Replacement .
3. Remove the upper exhaust pipe hanger bolts.
4. Remove the exhaust pipe hanger.

1. Install the exhaust pipe hanger.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the upper exhaust pipe hanger bolts.

Tighten
Tighten the exhaust pipe hanger bolts to 50 N·m (37 lb ft).

3. Install the floor panel tunnel reinforcement. Refer to Floor Panel Tunnel Panel Reinforcement Replacement .
4. Install the intermediate exhaust pipe. Refer to Intermediate Pipe Replacement .