Drive Belt Idler Pulley Replacement w/o LS9
Removal Procedure
- Remove the accessory drive belt. Refer to
Drive Belt Replacement - Accessory.
- Loosen the drive belt idler pulley mounting bolt.
- Remove the drive belt idler pulley.
Installation Procedure
- Position the drive belt idler pulley on generator mounting bracket.
- Hand tighten the drive belt idler pulley mounting bolt.
Notice: Refer to Fastener Notice in the Preface section.
- Tighten the drive belt idler pulley bolt.
Tighten
Tighten the drive belt idler pulley bolt to 50 N·m (37 lb ft).
- Install the accessory drive belt. Refer to
Drive Belt Replacement - Accessory.