Gear Select/Skip Shift Solenoid Replacement for Chevrolet Corvette 2008

Special Tools

DT-48827 Gear Select/Reverse Lockout Solenoid Socket

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Disconnect the gear select solenoid electrical connector.



3. Using the DT-48827 , remove the gear select solenoid.

Notice: Refer to Component Fastener Tightening Notice in the Preface section.




1. Using the DT-48827 , install the gear select (skip shift) solenoid.

Tighten
Tighten the gear select solenoid to 40 N·m (30 lb ft).




2. Connect the gear select solenoid electrical connector.
3. Lower the vehicle.