Removal Procedure
- Remove the console. Refer to Console Replacement.
- Remove the passenger seat. Refer to Driver and Passenger Seat Replacement.
- Lift and disengage the retainer clips on the park brake lever boot.
- Lift the park brake lever slightly until it engages the first stop.
- Remove the park brake lever assembly mounting bolts.
- Disconnect the electrical connector from the park brake switch.
- Position the park brake lever assembly to the rear of the vehicle.
- Remove the park brake switch.
Installation Procedure
- Install the park brake switch to the park brake lever assembly.
- Position the park brake lever assembly to the driveline tunnel.
- Connect the electrical connector to the park brake switch.
- Install the mounting bolts to the park brake lever assembly.
- Position the park brake lever assembly boot to the driveline tunnel.
- Install the park brake lever assembly boot nuts.
- Install the passenger seat. Refer to Driver and Passenger Seat Replacement.
- Install the console. Refer to Console Replacement.
- Release the park brake lever.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the park brake lever assembly mounting bolts to 28 N·m (21 lb ft).
Tighten
Tighten the park brake lever assembly boot nuts to 10 N·m (89 lb in).
