GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Corvette 🢒 Suspension 🢒 Rear Suspension 🢒 Stabilizer Shaft Link Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .

    3. Object Number: 922511 Size: SH
  3. Using a back-up wrench to prevent the link stud from rotating, remove the stabilizer shaft link nuts from the lower control arms.
  4. Using a back-up wrench to prevent the link stud from rotating, remove the stabilizer shaft link nuts and links from the shaft.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 922511 Size: SH
  1. Using a back-up wrench to prevent the link stud from rotating, install the stabilizer shaft links and link nuts to the stabilizer shaft and to the lower crossmember.

    2. Tighten
    Tighten the stabilizer shaft link nuts to 76 N·m (56 lb ft).

  2. Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
  3. Lower the vehicle.