GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Corvette 🢒 Transmission/Transaxle 🢒 Manual Transmission - Tremec 6-Speed 🢒 Shift Control Shift Closeout Boot Replacement

Removal Procedure
  1. Remove the shift control knob. Refer to Transmission Control Lever Knob Replacement.

    2. Object Number: 180587 Size: SH
  2. Grasp the sides of the shift control boot and apply light pressure in toward the shift control lever to begin to release the shift boot retaining tabs from the instrument panel (I/P) accessory trim plate.
  3. Using light pressure, continue to release the remaining boot retaining tabs.

    4. Object Number: 71519 Size: SH
  4. Lift the boot away from the trim plate and remove the boot.
  5. Remove the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement.

    6. Object Number: 71524 Size: SH
  6. Remove the shift control closeout boot retaining nuts.
  7. Remove the shift control closeout boot.

Installation Procedure

    Object Number: 71523 Size: SH
  1. Install the shift control closeout boot.

    2. Check that the closeout boot fully seats to the shift control lever seal and the base of the shift control assembly (1).

    Notice: Refer to Fastener Notice in the Preface section.

  2. Install the shift control closeout boot retaining nuts.

    3. Tighten
    Tighten the shift control closeout boot retaining nuts to 12 N·m (106 lb in).


    Object Number: 71519 Size: SH
  3. Install the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement.
  4. Install the shift control boot over the shift control lever.

    5. Object Number: 180589 Size: SH
  5. Align the shift control boot to the I/P accessory trim plate opening, then press to lock the boot retaining tabs.
  6. Adjust the shape of the boot for appearance, if necessary.
  7. Install the shift control knob. Refer to Transmission Control Lever Knob Replacement.
  8. Install the console. Refer to Console Replacement.