For 1990-2009 cars only
Removal Procedure
- Disable the SIR system. Refer to SIR Disabling and Enabling .
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
- Remove all related panels and components.
- Note the location and remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair .
- Remove the welds (1) attaching the tow hook to the impact bar.
- Remove the tow hook (1) from the impact bar.
Installation Procedure
- Clean and prepare all of the welded surface and apply 3M weld-thru coating P/N 05916 or equivalent as necessary.
- Position the tow hook (1) to the passenger side of the impact bar.
- From the right outer edge of the impact bar (2) measure 269 mm (10 5/8 in) to the center of the tow hook (1).
- Using a metal inert gas (MIG) welder, weld a 51 mm (2 in) stitch along the tow hook to the impact bar in 4 places (1).
- Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair .
- Paint the repair area. Refer to Basecoat/Clearcoat Paint Systems .
- Install all related panels and components.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
- Enable the SIR system. Refer to SIR Disabling and Enabling .
| • | Front |
| • | Rear |
| • | Inboard side |
| • | Outboard side |
