Removal Procedure
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Drain the engine oil. Refer to
Engine Oil and Oil Filter Replacement.
- Remove the right front wheelhouse rear liner. Refer to
Front Wheelhouse Liner Replacement.
- Remove the oil inlet/outlet hose bracket bolt.
Important: Anytime the oil tank inlet and outlet hoses
are serviced, the oil seals must be replaced.
- Remove the inlet hose to oil tank bolt (3) and disconnect the hose (2)
from the oil tank. Discard the oil seal (1).
- Remove the inlet hose to oil pan bolt (3) and
disconnect the hose (2) from the oil pan. Discard the oil seal (1).
- Remove the oil inlet hose.
Installation Procedure
- Position the oil inlet hose.
Notice: Refer to Fastener Notice in the Preface section.
- Install the oil inlet/outlet hose bracket bolt.
Tighten
Tighten the oil inlet/outlet hose bracket bolt to
22 N·m (16 lb ft).
- Using a new oil seal (1) install the oil inlet
hose (2) and bolt (3) to the oil pan.
Tighten
Tighten the inlet hose to oil pan bolt to 22 N·m
(16 lb ft).
- Using a new oil seal (1) install the oil inlet
hose (2) and bolt (3) to the oil tank.
Tighten
Tighten the inlet hose to oil tank bolt to 22 N·m
(16 lb ft).
- Install the right front wheelhouse rear liner. Refer to
Front Wheelhouse Liner Replacement.
- Lower the vehicle.
- Change the engine oil. Refer to
Engine Oil and Oil Filter Replacement.