GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 73209  Size: SH
  1. Remove the tilt wheel lever (4). Refer to Tilt Lever Replacement .
  2. Remove the driver knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .
  3. Separate and remove the upper (1) and the lower (3) steering column covers.

  4. Object Number: 70097  Size: SH
  5. Disconnect the electrical connector from the wiring harness.
  6. Release the upper and lower retaining clips and slide the wiper/washer switch from the steering column lock module.

Installation Procedure


    Object Number: 70097  Size: SH
  1. Slide the wiper/washer switch into the steering column lock module until the upper and lower retaining clips snap into place.
  2. Connect the electrical connector into the wiring harness.

  3. Object Number: 73209  Size: SH
  4. Install the upper (1) and the lower (3) steering column covers.
  5. Install the tilt wheel lever (4). Refer to Tilt Lever Replacement .
  6. Install the driver knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .