Valve Rocker Arm and Push Rod Cleaning and Inspection 6.2L LS3

Note: Parts that are to be used again must be marked, sorted or organized for assembly.

1. Mark, sort, or organize the components for assembly. Refer to Separating Parts.
2. Clean the components with cleaning solvent.

Warning: Refer to Safety Glasses Warning in the Preface section.

3. Dry the components with compressed air.
4. Inspect the valve rocker arms bearings (2) for binding or roughness.
5. Inspect the valve rocker arm pushrod sockets (3) and valve stem mating surfaces (1). These surfaces should be smooth with no scoring or exceptional wear.
6. Inspect the pushrods for worn or scored ends. These surfaces should be smooth with no scoring or exceptional wear.
7. Inspect the pushrods for bends. Roll the pushrod on a flat surface to determine if the pushrod is bent.
8. Inspect the pushrod oil passages for restrictions.
9. Inspect the rocker arm pivot supports for cracks, wear, or other damage.

Valve Rocker Arm and Push Rod Cleaning and Inspection 6.2L LS9

Note: Parts that are to be used again must be marked, sorted or organized for assembly.

1. Mark, sort, or organize the components for assembly. Refer to Separating Parts.
2. Clean the components with cleaning solvent.

Warning: Refer to Safety Glasses Warning in the Preface section.

3. Dry the components with compressed air.
4. Inspect the valve rocker arm bearings (2) for binding or roughness.
5. Inspect the valve rocker arm pushrod sockets (3) and valve stem mating surfaces (1). These surfaces should be smooth with no scoring or exceptional wear.
6. Inspect the pushrods for worn or scored ends. These surfaces should be smooth with no scoring or exceptional wear.
7. Inspect the pushrods for bends. Roll the pushrod on a flat surface in order to determine if the pushrod is bent.
8. Inspect the pushrod oil passages for restrictions.

Valve Rocker Arm and Push Rod Cleaning and Inspection 7.0L

Note: Parts that are to be used again must be marked, sorted or organized for assembly.

1. Mark, sort, or organize the components for assembly. Refer to Separating Parts.
2. Clean the components with cleaning solvent.

Warning: Refer to Safety Glasses Warning in the Preface section.

3. Dry the components with compressed air.
4. Inspect the valve rocker arm bearings (2) for binding or roughness.
5. Inspect the valve rocker arm pushrod sockets (3) and valve stem mating surfaces (1). These surfaces should be smooth with no scoring or exceptional wear.
6. Inspect the pushrods for worn or scored ends. These surfaces should be smooth with no scoring or exceptional wear.
7. Inspect the pushrods for bends. Roll the pushrod on a flat surface in order to determine if the pushrod is bent.
8. Inspect the pushrod oil passages for restrictions.