GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Corvette 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Inside Air Temperature Sensor Replacement

Removal Procedure
  1. Remove the knee bolster. Refer to Driver Knee Bolster Panel Replacement.
  2. Remove the driver information center (DIC) retaining screw.
  3. Disconnect DIC from the instrument panel (I/P).
  4. Disconnect the inside air temperature sensor from the DIC bezel.

    5. Object Number: 922611 Size: SH
  5. Disconnect the inside air temperature sensor electrical connector.

Installation Procedure
  1. Connect the inside air temperature sensor electrical connector.

    2. Note: Ensure that the inside temperature sensor is fully seated into the DIC bezel.


    Object Number: 922611 Size: SH
  2. Install the inside air temperature sensor.
  3. Connect DIC to the I/P.

    4. Caution: Refer to Fastener Caution in the Preface section.

  4. Install the DIC retaining screw.

    5. Tighten
    Tighten the screw to 1.9 N·m (17 lb in).

  5. Install the knee bolster. Refer to Driver Knee Bolster Panel Replacement.