GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Corvette 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Electronic Suspension Front Position Sensor Replacement

Removal Procedure
  1. Turn OFF the ignition switch.
  2. Raise the vehicle on a suitable safety stand. Refer to Lifting and Jacking the Vehicle.
  3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.

    4. Object Number: 70242 Size: SH
  4. Disconnect the position sensor connector (3).
  5. Remove the position sensor harness retainers.
  6. Remove the position sensor link from the control arm link stud (2).
  7. Remove the position sensor mounting bolts (4).
  8. Remove the position sensor (1) from the vehicle.

Installation Procedure

    Object Number: 70242 Size: SH
  1. Install the position sensor (1) in the vehicle.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the position sensor mounting bolts (4).

    3. Tighten
    Tighten the bolts to 3 N·m (26 lb in).

  3. Install the position sensor link to the control arm link stud (2).
  4. Connect the position sensor electrical connector (3).
  5. Secure the position sensor harness with the retainers.
  6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
  7. Lower the vehicle.