GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Corvette 🢒 Suspension 🢒 Rear Suspension 🢒 Stabilizer Shaft Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation.

    3. Object Number: 922511 Size: SH
  3. Using a back-up wrench to prevent the link stud from rotating, remove the stabilizer shaft link nuts from the stabilizer shaft.
  4. Remove the stabilizer shaft clamps, bolts and nuts retaining the shaft to the crossmember.
  5. Remove the stabilizer shaft from the vehicle.

Installation Procedure

    Object Number: 922511 Size: SH
  1. Install the stabilizer shaft to the vehicle.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the stabilizer shaft insulator clamps to the stabilizer shaft and the crossmember.

    3. Tighten

        • Tighten the stabilizer shaft insulator clamp bolts to 100 N·m (74 lb ft).
        • Tighten the stabilizer shaft insulator clamp nuts to 95 N·m (70 lb ft).
  3. Using a back-up wrench to prevent the link stud from rotating, install the stabilizer shaft links to the stabilizer shaft.

    4. Tighten
    Tighten the stabilizer shaft link nuts to 76 N·m (56 lb ft).

  4. Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation.
  5. Lower the vehicle.