GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Corvette 🢒 Body Systems 🢒 Mirrors 🢒 Sunshade Replacement

Removal Procedure

    Object Number: 71191 Size: SH
  1. Tilt the sunshade down toward the windshield.

    2. Caution: In order to avoid damage to the sunshade and/or bezel, apply tape to the flat-bladed tool.

  2. Insert a flat-head screwdriver blade into the slot in the sunshade inner bezel.
  3. Using the screwdriver against the elbow of the sunshade arm for leverage pull down on the sunshade arm while rotating the sunshade outboard until the sunshade stops. The first tab disengages.
  4. Push up on the sunshade and continue rotating the sunshade outboard until the sunshade with the inner bezel disengages from the mounting bezel.

    5. Object Number: 71190 Size: SH
  5. Disconnect the electrical connector.
  6. Remove the sunshade and bezel.

    7. Discard the bezel, it cannot be reused.

Installation Procedure

    Object Number: 71190 Size: SH
  1. Route the harness through a NEW mounting bezel.
  2. Insert the mounting bezel into the garnish molding engaging the snap fingers.
  3. Connect the harness to the sunshade electrical connector.
  4. Push the connector up through the bezel and through the hole in the garnish molding.
  5. Position the sunshade approximately midway between the windshield and the side of the vehicle.
  6. Insert the rod with inner bezel firmly attached fully into the mounting bezel.
  7. Rotate the sunshade toward the centerline of the vehicle until the sunshade locks in place.