GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Corvette 🢒 Brakes 🢒 Park Brake 🢒 Parking Brake Actuator Replacement

Removal Procedure

    Object Number: 64008 Size: SH
  1. Remove the rear brake rotor. Refer to Rear Brake Rotor Replacement.
  2. Rotate the park brake adjuster nut until the bolt is in the closed position.
  3. Remove the park brake shoe retaining spring.

    4. Object Number: 64007 Size: SH
  4. Remove the park brake shoe assembly by grasping the shoe and spreading slightly while pulling the shoe from the actuator assembly.

    5. Object Number: 338243 Size: SH
  5. Remove the two actuator mounting bolts.
  6. Remove the actuator assembly from the dust shield.

Installation Procedure

    Object Number: 64006 Size: SH
  1. Apply high temperature, silicone lubricant to positions 1 and 2. Do not apply grease to the bolt threads (3).
  2. Install the actuator to the dust shield.
  3. Apply high temperature, silicone lubricant to the brake caliper bolt shaft. Do not lubricate the bolt threads.

    4. Caution: Refer to Fastener Caution in the Preface section.

  4. Install the actuator mounting bolts.

    5. Tighten
    Tighten the actuator mounting bolts to 70 N·m (52 lb ft).


    Object Number: 64007 Size: SH
  5. Install the park brake shoe assembly by grasping the shoe and spreading slightly while pulling the shoe over the actuator assembly.

    6. Object Number: 64008 Size: SH
  6. Install the park brake shoe retaining spring.
  7. Adjust the park brake. Refer to Parking Brake Adjustment.
  8. Install the brake rotor. Refer to Rear Brake Rotor Replacement.