GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Corvette 🢒 Transmission 🢒 Clutch 🢒 Clutch Master Cylinder Replacement

Removal Procedure

    Warning: Refer to Battery Disconnect Warning in the Preface section.


    Object Number: 1617694 Size: SH
  1. Disconnect the negative battery cable.
  2. Remove the left instrument panel (I/P) lower insulator panel. Refer to Instrument Panel Insulator Panel Replacement.
  3. Remove the clutch master cylinder rod retainer (1).
  4. Remove the clutch master cylinder rod (2) from the clutch pedal.
  5. Remove the windshield washer solvent container. Refer to Windshield Washer Solvent Container Replacement.

    6. Object Number: 1617698 Size: SH
  6. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
  7. Remove the clutch actuator cylinder hose from the hose retaining clip, under the brake master cylinder.
  8. Remove the clutch hose connection retaining clip (6).
  9. Separate the clutch hose (5) from the clutch master cylinder connection (4).
  10. Protect both hose coupling ends from dirt and damage.
  11. Lower the vehicle. Leave the vehicle on the hoist.
  12. Remove the clutch master cylinder reservoir (1) from the reservoir bracket (2).
  13. Rotate the clutch master cylinder 45 degrees.
  14. Release the clutch master cylinder (3) from the dash panel.
  15. Remove the clutch master cylinder (3) and reservoir (1) from the vehicle.

Installation Procedure

    Object Number: 1617699 Size: SH
  1. Install the clutch master cylinder (3) and the reservoir (1) into position.
  2. Install the clutch master cylinder (3) to the dash panel.
    3. 2.1. Orientate the clutch master cylinder at a 45 degree angle.
    2.2. Insert the clutch master cylinder into the dash panel.
    2.3. Rotate the master cylinder to secure.

    DO NOT over-rotate the master cylinder.

  3. Install the clutch master cylinder reservoir (1) to the reservoir bracket (2).
  4. Install the windshield washer solvent container. Refer to Windshield Washer Solvent Container Replacement.
  5. Raise the vehicle.
  6. Install the clutch hose connection retaining clip (6).

    7. Note: DO NOT rely on an audible click or a visual verification of the clutch hydraulic hose quick connect fitting connection.

  7. Connect the clutch actuator cylinder hose (5) to the clutch master cylinder hose (4).

    8. Push together the clutch hydraulic hose quick connect fittings, then pull back on the fittings to verify engagement.

  8. Check the clutch hydraulic hoses for twists or kinks.
  9. Install the clutch actuator cylinder hose to the hose retaining clip, under the brake master cylinder.
  10. Lower the vehicle.

    11. Object Number: 1617694 Size: SH
  11. Install the clutch master cylinder rod (2) to the clutch pedal.
  12. Install the clutch master cylinder rod retainer (1).
  13. Install the left I/P lower insulator panel. Refer to Instrument Panel Insulator Panel Replacement.

    14. Caution: Refer to Fastener Caution in the Preface section.

  14. Connect the negative battery cable.

    15. Tighten
    Tighten the negative battery cable bolt to 15 N·m (11 lb ft).

  15. Program the transmitters. Refer to Transmitter Programming.
  16. Bleed the clutch hydraulic system. Refer to Hydraulic Clutch Bleeding.