Engine control module (ECM) service should normally consist of either ECM replacement or electrically erasable programmable read only memory (EEPROM) programming. If the diagnostic procedures require ECM replacement, check the ECM first to see if the correct part is being used.

Note: In order to prevent internal ECM damage, the ignition must be OFF when you disconnect or reconnect the power to the ECM. For example, disconnect the power when you work with the following components:

Note: 

Important: It is necessary to record the remaining engine oil life. If the replacement module is not programed with the remaining engine oil life, the engine oil life will default to 100 percent. If the replacement module is not programmed with the remaining engine oil life, the engine oil will need to be changed at 5 000 km (3,000 mi) from the last engine oil change.

1. Using a scan tool, retrieve the percentage of remaining engine oil. Record the remaining engine oil life.
2. Remove the wheelhouse filler panel. Refer to Front Wheelhouse Liner Replacement .
3. Remove the ECM bolts (1).



4. Remove the ECM from the bracket and allow the ECM to hang down from the engine wiring harness.
5. Disconnect the engine wiring harness electrical connectors (1) from the ECM.
6. Remove the ECM.

1. Position the ECM.
2. Connect the engine wiring harness electrical connectors (1) to the ECM and position the ECM into the bracket.

Caution: Refer to Fastener Caution in the Preface section.




3. Install the ECM bolts (1) and tighten to 10 N·m (89 lb in). .
4. Install the wheelhouse filler panel. Refer to Front Wheelhouse Liner Replacement .
5. If a new ECM is being installed, program the ECM. Refer to Control Module References .