GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Corvette 🢒 Power and Signal Distribution 🢒 Data Communications 🢒 Blower Motor Replacement

Removal Procedure
  1. Remove the right hand (RH) insulator panel. Refer to Instrument Panel Insulator Panel Replacement.

    2. Warning: Unplug the blower motor before removal. Blower motor case contact with any ground may start the fan and cause personal injury.

    Note: The blower motor resistor is internal to the blower motor assembly and is not serviced separately.

  2. Disconnect the blower motor electrical connector.

    3. Object Number: 907907 Size: SH
  3. Remove the blower motor retaining screws.
  4. Remove the blower motor from the HVAC module.

Installation Procedure

    Object Number: 907907 Size: SH
  1. Install the blower motor to the HVAC module.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the blower motor retaining screws.

    3. Tighten
    Tighten the screws to 1.6 N·m (14 lb in).

  3. Connect the blower motor electrical connector.
  4. Install the RH insulator panel. Refer to Instrument Panel Insulator Panel Replacement.